Snapper SPLHI53KW From previous, Shift Lever ARM Dlebar Loosen Bolt Connected

Models: SPLHI53KW

1 36
Download 36 pages 22.13 Kb
Page 15
Image 15

SECTION 3 -OPERATING INSTRUCTIONS

3.8 HANDLE HEIGHT ADJUSTMENT

(Continued from previous page)

STEP 3: Insert rod (5/16" diameter x 20" long) through alignment holes in the left and right traction control shift lever arms and the tank support bracket. The rod should pass through both the left and right traction control shift lever arms. See Figure 3.8.

LEFT & RIGHT TRACTION

CONTROL SHIFT LEVER ARMS

....TANK SUPPORT BRACKETS

FIGURE 3.8

STEP 4: Disconnect the swivel from the right and left traction control arms and loosen swivel jam nuts. See Figure 3.7.

STEP 5: Loosen the upper bolt and nut on right and

left side of Mower which holds Handlebar to Support Bracket. Remove the lower bolt and nut on each side.

Retain this hardware. See Figure 3.9.

STEP 7: Adjust swivel (Clockwise or Counter- Clockwise) until the pin on the swivel aligns perfectly with the hole in the traction control arm. The traction

control lever must be held in the Neutral Latch position

when making this adjustment. Complete this adjustment for both left and right swivels. Carefully reattach and secure swivels to control arms. Tighten swivel jam nuts. IMPORTANT: Both the left and the right swivels must be installed in the same traction control arm speed range setting. Mid range (middle hole) setting is recommended.

STEP 8: Remove steel rod from shift lever arms.

STEP 9: Check to insure machine is securely blocked. Start engine. Drive wheels should not rotate with both Traction Levers latched in the Neutral position. If no rotation is observed the handlebar adjustment procedure is complete. If wheels do rotate proceed to next step. STOP ENGINE.

STEP 10:Wheel rotation will be stopped by adjusting the eccentric on the pump arms on the right and left pumps. Turning the eccentric slightly clockwise or counter-clockwise will synchronize the pump and traction controls for Neutral. See Figure 3.10. To turn the eccentric, first loosen the bolt in the pump control arm and the nut and bolt fastening the eccentric to the pump control arm. With both Traction Levers latched in Neutral, start engine. Turn eccentric slightly clockwise

or counter-clockwise until wheels stop rotating. Tighten control arm bolts and eccentric nut and bolts. Check for

wheel rotation. Repeat eccentric adjustment if needed.

TRACTION

 

i

CONTROL

SHIFT

t

LEVER ARM

1

 

I

DLEBAR

 

 

LOOSEN BOLT

 

I

CONNECTED

 

I

ARM

I

I

 

I

I

LOOSEN BOLT

& NUT THAT

I

CONNECTS ECCENTRIC TO CONTROL

ARM

 

 

 

CLOCKWISE OR COUNTER-

FUEL

 

 

ROTATE

ECCENTRIC

 

 

CLOCKWISE

TANK/HANDLEBAR

 

 

SUPPORT

BRACKET

 

 

I

SHOWN

IN PHANTOM

_

_

'

 

 

i

.J

 

 

 

/-

 

REMOVELOWER

 

[ LEFT SIDE OF MACHINE

SHI3WN

/

BOLT & NUT

FIGURE 3.10

FIGURE 3.9

STEP 6: Pivot the Handlebar up or down and reinsert bolt and nut into desired hole position on each side. Tighten both upper and lower bolts and nuts on each side to 35 to 45 ft. Ibs.

15

Page 15
Image 15
Snapper SPLHI53KW important safety instructions From previous, Shift Lever ARM Dlebar Loosen Bolt Connected