_ Malfunctions
Causes and how to eliminate them
Indicator | Remedy | |
|
| |
An acoustic signal confirms |
| |
that entry was correct |
| |
Incorrect entries are indicated |
| |
by 5 acoustic signals in swift |
| |
succession. |
| |
| Check that your entry is | |
| correct - if necessary interrupt | |
| the command sequence by | |
| pressing ”C” or ”CI”. | |
|
| |
The scale sets the value zero | Remove the items from the | |
weighing platform. Remove | ||
automatically when it is | ||
any dirt. If the scales do not | ||
switched on. If the scales are | ||
indicate zero after a couple of | ||
outside the set tolerance | ||
seconds, you should contact | ||
range, | ||
your service partner. | ||
| ||
|
| |
Underload: only the | Switch the scales off and on | |
bottom horizontal lines | again. The zero point will be | |
appear on the display. | reset automatically. | |
|
| |
Overload: Only the top | Remove some of the items to | |
horizontal lines appear on | be weighed from the scales. | |
the display. The maximum |
| |
weighing range has been |
| |
exceeded. |
| |
|
| |
Weight of item too light. |
| |
The zero setting range has |
| |
been exceeded |
| |
Taring is not possible in case |
| |
of over- or underloaded |
| |
balance |
| |
Printing is not possible in case |
| |
of over- or underloaded |
| |
balance. |
| |
kg / lb conversion is blocked |
|
Totals memory occupied
-must be cleared before commutation -
The connection between the reference scale and the indicator is disturbed
Plug and reference scale are not identical.
In case of all error indications: Please contact your
17