Sonic Alert MS30H/MS30E MIXER - GENERAL INFORMATION, General, Before Starting, Oil Levels

MS30H/MS30E MIXER — GENERAL INFORMATION

GENERAL

The MQ STOW Model MS30H (Honda GX240K1) gasoline engine) and MS30E (electric motor) plaster and mortar mixers are shipped completely assembled and have been factory tested.

The drum batch capacity of these mixers is between 3.5 and

4.0bags. With proper care, they will give continuous service year-after-year.

These mixers can be powered by either gasoline or electric motors.The shaft of the engine or electric motor is connected to a drive belt pulley which is attached to a main gear. As the main gear rotates it causes the paddle shaft to rotate.

BEFORE STARTING

Before starting the engine, read the engine owners manual and thoroughly understand the safety information.

Check the items listed below:

OIL LEVELS

Be sure to check the oil levels in the engine and engine reduction unit before starting the unit (gasoline model only).

HARDWARE

Check all hardware on the mixer before starting. Periodically inspect all hardware. Loose hardware can contribute to early component failure and poor performance. Use the torque chart below as a general guideline and keep all hardware tight:

GASOLINE ENGINE CARE

For care and operation of the gasoline engine, refer to the engine manufacturer’s operating instructions furnished with the engine. We recommend draining and refilling the engine crankcase at least every thirty hours of operation. Check the engine oil level daily.

GASOLINE MIXER OFF/ON SWITCH

This feature is on gasoline engine mixers only. Located on the side of the engine cover. The purpose of this switch is to start and stop the mixer in normal operation.

ELECTRIC MOTOR MIXER OFF/ON SWITCH

This feature is on electric motor mixers only.This switch is located on top of the motor. Lift the engine cover to gain access to this switch.The purpose of this switch is to start and stop the mixer in normal operation. NEVER use the electric motor in an explosive environment.

ENGINE THROTTLE AND CHOKE CONTROLS

Please refer to the engine owners manual for specific instructions.

HARDWARE DIA

5/16"- 18

3/8" - 24

1/2" - 13

1/2" - 13 (Grade 8)

NOTE

TORQUE (LB./FT.)

24

37

39

90

In accordance with our established policy of constant improvement, we reserve the right to amend these specifications at any time without notice.

MQ STOW MS30H/MS30E MIXER — PARTS & OPERATION MANUAL — REV. #4 (08/10/06) — PAGE 13