MS30H/MS30E MIXER — INITIAL START-UP
8.Place the belt slip lever (Figure 21) in the mix position. This will tilt the engine placing tension on the
Figure 21. Belt Slip Lever
(Mix Position)
Starting (electric only)
1.Using an adequate size extension cord (see Table 4), connect one end of the extension cord to the plug on the electric motor, connect the other end to the power source. Make sure the motor is configured for the proper operating voltage.
2.Set the electric motor's ON/OFF switch (Figure 3) to the ON position.
Mixing Dumping
1.The paddle shaft inside the drum should be rotating at this time.
2.Lift the mixing bag compound onto the steel grate over the bag cutter and let the contents fall into the drum.
3.Add water, and mix compound to desired consistency.
4.When charging, mixing, or dumping a batch of plaster or mortar the drum lock pin should be placed to the left (when viewing the mixer from the towpole end) of the drum stop block which is welded to the front side of the drum. See Figure 22.
This will allow the operator to use both hands on the drum handle during dumping. Please note that when the lock pin is placed to the left, the drum will only rotate in a clockwise direction. When the dump handle is released, the drum will return to an upright position.
Figure 22. Drum Lock Pin (Left Position)
Be sure to stand clear of the
NOTEdump handle when the mixer is operational. Any binding of material between the mixer
blades and the drum will cause the drum handle to move to the discharge position, thus causing bodily harm.
Starting (electric only)
1.Using an adequate size extension cord (see Table 4), connect one end of the extension cord to the plug on the electric motor, connect the other end to the power source. Make sure the motor is configured for the proper operating source.
2.Set the electric motor's ON/OFF switch (Figure 3) to the ON position.
STOPPINGTHE MIXER (gasoline)
1.Place the belt slip lever in the start/stop position.
2.Push the main start/stop switch (Figure 8) inward to stop the engine.
3.Turn the fuel
4.Disconnect the spark plug.
5.Clean drum of all debris and foreign matter.
STOPPINGTHE MIXER (electric)
1.Place the electric motor's start/stop switch (Figure 3) in the OFF position.
2.Disconnect the electric motor's extension cord from its power source.
3.Clean drum of all debris and foreign matter
MQ STOW MS30H/MS30E MIXER — PARTS & OPERATION MANUAL — REV. #4 (08/10/06) — PAGE 27
