MS30H/MS30E MIXER — MAINTENANCE
WHEEL BEARINGS
After every 3 months of operation, remove the hub dust cap and inspect the wheel bearings. Once a year, or when required, disassemble the wheel hubs remove the old grease and repack the bearings forcing grease between rollers, cone and cage with a good grade of high speed wheel bearing grease (never use grease heavier than 265 A.S.T.M. penetration (“No. 2.”) Fill the wheel hub with grease to the inside diameter of the outer races and also fill the hub grease cap.
Reassemble the hub and mount the wheel. Then tighten the adjusting nut, at the same time turn the wheel in both directions, until there is a slight bind to be sure all the bearing surfaces are in contact.
Then
DRUM HEAD SEAL CARE
Grease every 40 hours of operation using any grade #1 lithium base grease. Appy grease until visible inside of mixing tub (over grease).This will purge the seal system of contamination.
PADDLE SHAFT BEARINGS
The paddle shafts in the MQ STOW mixers rotate in sealed ball bearings, which require no additional lubrication as they are packed and sealed at the factory.
There is, on each end of the mixing drum, an zerk grease fitting. Oil these fittings two or three times each week as they lubricate the dumping mechanism of the mixing drum.
CAUTION:
Failure to lubricate the zerk grease fittings two or three times a week will cause the dumping mechanism to stiffen, making the mixer hard to dump.
BEARING BRACKET
Grease the bearing bracket every month.
GEAR ALIGNMENT
The countershaft and drive pinion are mounted on a slotted base.To align gears, loosen the pillow block mounting bolts and move them until the necessary alignment has been made.
GEAR LUBRICATION
The surface of the pinion and bull gear should be very lightly greased every 250 hours.IMPORTANT! avoid
Excess grease will accumulate contaminates and cause premature wear.
CLEANING
ALWAYS disconnect the spark plug wire before cleaning the inside of the drum.
NEVER pour or spray water over the gasoline engine or electric motor.
For consistent performance, long life and high quality mixing, thoroughly clean the mixer inside and out at the end of each day’s operation. To prevent lumps of dried mortar from forming and contamination of future batches, do not allow a buildup of materials to form on the blades or anywhere inside the drum.
PAGE 28 — MQ STOW MS30H/MS30E MIXER — PARTS & OPERATION MANUAL — REV. #4 (08/10/06)
