Sonic Alert MS30H/MS30E MIXER - RULES FOR SAFE OPERATION, Transporting, Maintenance Safety

MS30H/MS30E MIXER — RULES FOR SAFE OPERATION

■Stop the engine when leaving the mixer unattended.

■Block the unit when leaving or when using on a slope.

■Maintain this equipment in a safe operating condition at all times.

■ALWAYS stop the engine before servicing, adding fuel and oil.

■NEVER Run engine without air filter. Severe engine may occur.

■ALWAYS service air cleaner frequently to prevent carburetor malfunction.

■ALWAYS be sure the operator is familiar with proper safety precautions and operations techniques before using mixer.

■ALWAYS store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children.

■DO NOT operate this equipment unless all guards and safety devices are attached and in place.

■CAUTION must be exercised while servicing this equipment. Rotating and moving parts can cause injury if contacted.

■When towing, an adequate safety chain must be fastened to the frame, refer to page 19.

■Keep all inexperienced and unauthorized people away from the equipment at all times.

■Unauthorized equipment modifications will void all warranties.

■Check all fasteners periodically for tightness. Also check towing tongue bolt, lock nut and wheel lug nuts for wear.

■Stop the engine and disconnect the spark plug before allowing anybody’s hands in the mixing drum.

■NEVER pour or spray water over the engine or electric motor.

■ALWAYS stand clear of dump handle when mixer is in operation. Any binding of material between the mixer blades and drum will cause drum and handle to quickly move in the discharge position.

■Depending on type of mixer, test the ON/OFF switch for either the gasoline engine or electric motor before operating. The purpose of these switches is to shut down the engine or motor of the mixer.

■Refer to the HONDA Engine Owner's Manual for engine technical questions or information recommended by Multiquip for this equipment. Damage to the equipment and/or injury to user may result.

Transporting

■ALWAYS shutdown engine before transporting.

■Tighten fuel tank cap securely and close fuel cock to prevent fuel from spilling.

■Drain fuel when transporting mixer over long distances or bad roads.

Maintenance Safety

■NEVER lubricate components or attempt service on a running mixer.

■ALWAYS allow the mixer a proper amount of time to cool before servicing.

■Keep the mixer in proper running condition.

■Fix damage to the mixer immediately and always replace broken parts.

■Dispose of hazardous waste properly.Examples of potentially hazardous waste are used motor oil, fuel and fuel filters.

■DO NOT use food or plastic containers to dispose of hazardous waste.

MQ STOW MS30H/MS30E MIXER — PARTS & OPERATION MANUAL — REV. #4 (08/10/06) — PAGE 9