| Specifications |
| Note: Power ratings based on a nominal power line input. All specifications are made |
| on the 8 ohm taps, utilizing an 8 ohm load unless otherwise specified. |
Power Output: | 110 watts continuous at 8, 4 and 2 ohms from 20 Hz to 20 kHz with less than 1% total |
| harmonic distortion terminated with rated load (typically <0.5% @ 110 watts 1 kHz) both |
| channels driven. Actual power output available at clipping (defined as <1% THD) |
| approximately 120 watts RMS |
SMPTE Intermodulation |
|
Distortion: | <1% 20 Hz to 20 kHz @ 110 watts output |
Power Bandwidth: | 15 Hz to 90 kHz |
(110 watt output) | 5 Hz to 110 kHz |
Frequency Response: | 5 Hz to 40 kHz @ 1 watt |
| 2 Hz to 120 kHz @ 1 watt |
Input Sensitivity | 1.25V RMS balanced for 110 watts output |
(for 110 watt output): | 1.25V RMS |
Input Impedance: | 200K ohms balanced |
| 100K ohms |
Damping Factor: | >50 (determined using the IHF method from |
Output Impedance: | 0.30 ohms at 1 kHz |
Negative Voltage Feedback: | 16 dB |
Hum and Noise: | approximately 400 microvolts of wideband, unweighted noise @ the 8 ohm taps, |
| input muted; |
Rise Time: | 3.0 microseconds |
Slew Rate: | 16 volts/microsecond |
Power Requirements: | |
| and 375VA with no signal input |
Tube Complement: | 8 (4 matched pair) x 6550C/KT88 - power output; 6 x 6922 - input/driver; 2 x 5687 |
| - high voltage driver |
Dimensions: | 18” (46 cm) W x 22” (56 cm) D x 9” (23 cm ) H |
Weight (approx.): | 110 lbs (50 kg) net each (unpacked) |
| Sonic Frontiers continually strives to improve their products; specifications are |
| subject to change without notice. |
15