Troubleshooting
If at any time the amplifier should fail to work, follow these steps:
1.Check that all tubes are fully seated in correct sockets and all tube filaments are lit.
2.Check all connections at the rear panel.
3.Check that the amplifier is not in MUTE mode.
4.Check that the proper input is selected via the Selector Switch.
5.Check that the amplifier is in POWER ON mode and NOT in STANDBY mode.
6.Check other equipment and connections to that equipment in your system, from speak- ers to source.
7.Check that no fuses are blown in all equipment and/or breaker switches in the home. If this checklist fails to be fruitful, contact your dealer or Sonic Frontiers directly.
Servicing
If the amplifier ever requires servicing in or outside of the warranty limitations, contact your Sonic Frontiers dealer or Sonic Frontiers directly.
Break-in Time
As with all audio electronic products, the ultimate sonic character of the Power 2 will not be realized until and unless the unit receives a minimum of approximately 70 hours of signal
Safety Instructions
1.Water and Moisture - This product should not be used near water. To prevent fire or shock hazard, do not expose this product to rain or moisture.
2.Heat - This product should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances which produce heat.
3.Power Sources - This product should be connected to an AC power source of the proper rated voltage. The original shipping container will stipulate the AC voltage this unit can operate with correctly.
4.Servicing - Do not open this product for any reason. No user serviceable parts inside. Refer servicing to an authorized service technician.
5.
6.Do not remove the top or bottom covers while the unit is “on”, or connected to an AC power source. Cover screws could fall through the ventilation slots and cause electrical damage to the amplifier.
13
