|
| Controls, Functions and Connections |
| Front Panel | Refer to Reference Diagrams. |
C | Power Switch | This switch provides control over the AC power from your wall outlet. When OFF (out |
|
| position) nothing on the amplifier is functional. When ON (depressed) the amplifier will |
|
| operate normally (green power LED indicates ON; Red Power LED indicates ON but in |
|
| MUTE mode). |
D | Standby Switch | This switch when OFF (out position) will allow normal operation of the amplifier (indicat- |
|
| ed by the green Standby LED, assuming Power ON). When depressed ON the amplifier |
|
| will be placed in STANDBY mode and will not be operational (indicated by the red |
|
| standby LED, assuming Power ON). In this mode, a small amount of current will remain |
|
| flowing through the tubes, this reduces power consumption and extends tube life during |
|
| periodic short term |
|
| occur, or a short time prior to a listening session so the amplifier is warm and ready). |
|
| This mode also will keep optimal warm up times of the tubes shorter. For periods |
|
| between listening sessions extending over a 12 hour period, it is recommended that the |
|
| Power 2 is turned off via the Power Switch. |
E | Power LED | When this LED is off, so is the amplifier. When the LED is glowing red, both chnnels are |
|
| Muted, controlled by the Input Selector Switches (I). When the LED is green, the amplifier |
|
| is receiving power and both inputs are selected, the amplifier is ready for operation. |
|
| (Green Power LED indicates ON; Red Power LED indicates ON but in MUTE mode; |
|
| Green + Red (Orange) indicates one channel is in MUTE and one channel is selected). |
F | Standby LED | When this LED is off, so is the amplifier. When the LED is glowing red, this indicates the |
|
| amplifier is in Standby mode, controlled by the Standby Switch. When the LED is green |
|
| the amplifier is in operate mode. |
| Rear Panel | Refer to Reference Diagrams. |
G | Detachable Power | Plug the detachable Power Cord into this socket. The Power 2 amplifier is configured |
| Cord Socket | for the operating voltages in which they are sold. See shipping box or Voltage/ |
|
| Impedance sticker on rear of the chassis for voltage settings. If a different operating |
|
| voltage is required, please contact an authorized Sonic Frontiers dealer or the factory |
|
| directly. |
H Fuse Location | This socket/holder houses a 7 amp |
| rated between |
| a |
| REPLACEMENT FUSES MUST BE RATED WITH THE SAME SPECIFICATIONS |
| AS THE ORIGINAL FUSE. |
8