Quick Setup
At this point we urge you to read and understand this manual in its entirety. But if you desire immediate action and have skill and/or past experience with tube hardware, fol- low these steps.
1.Place the amp on a hard flat surface that will not impede airflow under the amplifier’s chassis (carpeting or area rugs are NOT acceptable as hard surfaces).
2.Ensure the Power 2 is in Mute mode (these selector switches are on the rear of the
chassis). When disconnecting and connecting cable, placing the amplifier in Mute is an excellent practice.
3.Tube bias was set at the factory prior to shipment. Tubes are also marked for their cor- responding socket location. Carefully inspect each and install appropriately. Check Installing the Tubes and Biasing of the Power Tubes (a must read) for further clarification.
4.Connect your preamplifier’s left and right balanced or
5.Connect the speakers to the positive (+) red and negative
6.Select the input for use via the selector switch:
7.Power up your system turning the power amplifier on last ensuring that both green LEDs are on (no Standby or Mute activation). Allow 5 minutes of warm up before operation.
2