Sony LCD Compatible Installation | Configuration and Connections |
|
|
|
|
Connecting System 4xi to Sony Projector under
[System 4xi model and software
versiondisplayed here]
(See note.)
(See note.)
(See note.)
(See note.) |
(Note: Information depends on System 4xi setup.)
If the System 4xi is already configured for a Sony
4. If it is not set up correctly, it will be necessary to change switch settings on the System 4xi ’s Main Controller Board. Begin at Step 1 to verify the correct configuration.
1.Use the Front Panel to display the Information Menu to verify that the System 4xi is already set up for the Sony
a.Press to display the MENU SELECT on the LCD screen.
b.Press or to step to Menu 8.
c.Press to select this menu.
}d. Press or to display the configuration. The example to the left is general, yours will show the System 4xi model name, the software version and the following information:
PRJ = SONY
PRJ BAUD = 38400 UNIT No. = 000
HST BAUD = 9600 (value depends upon setup Menu 3)
2.Go to the procedure on page
Config | Model |
| SW1 | SW2 | SW3 | SW4 | SW5 | SW6 | PROJ | Comm | ||
as | 1 | 2 | 3 | 4 |
|
|
|
|
| CABLE | Adapter | |
|
|
|
|
|
| |||||||
| Sony | off | on | off | on | 0 | 0 | 8 | E | 0 | J15 |
SW2 |
SW6 |
SW4 |
SW3 |
SW5 |
J15
SW1
4 | 3 | 2 | 1 |
ON
3.
4.Install the System 4xi in its place of operation (i.e. rack), but not powered on.
__________ Changes in some switch configurations are not detected until the power is
removed at the AC cord, and then restored.
Refer to the following connection diagram and continue.
Extron • System 4xi Switcher Series • User’s Manual • P/N | Page 5 |