Sony LCD Compatible Installation | Configuration and Connections |
|
|
|
|
Connecting System 4xi to Sony VPL-X600
[System
4xi model and soft
ware
version
displayed
here] 
(See note.)
(See note.) |
(See note.)
(See note.) |
(Note: Information depends on System 4xi setup.)
If the System 4xi is already configured for a Sony LCD
1.Use the Front Panel to display the Information Menu to verify that the System 4xi is already set up for the Sony LCD projector. Apply power to the System 4xi and do the following:
a.Press 
to display the MENU SELECT on the LCD screen.
b.Press 
or 
to step to Menu 8.
c. Press |
| to select this menu. |
| ||
| ||
d. Press | or | to display the configuration. The example to the left is general, |
}yours will show the System 4xi model name, the software version and the following information:
PRJ = SONY
PRJ BAUD = 9600
UNIT No. = 000
HST BAUD = 9600 (value depends upon setup Menu 3)
2.Go to the procedure on page
Config | Model |
| SW1 | SW2 | SW3 | SW4 | SW5 | SW6 | PROJ | Comm | ||
as | 1 | 2 | 3 | 4 |
|
|
|
|
| CABLE | Adapter | |
|
|
|
|
|
| |||||||
✔ | Sony LCD | off | on | off | on | 0 | 0 | 3 | 5 | 1 | J15 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
SW2 |
SW6 |
SW4 |
SW3 |
SW5 |
J15
SW1
4 | 3 | 2 | 1 |
ON
3.
4.Install the System 4xi in its place of operation (i.e. rack), but not powered on.
__________ Changes in some switch configurations are not detected until the power is
removed at the AC cord, and then restored.
Refer to the following connection diagram and continue.
Extron • System 4xi Switcher Series • User’s Manual • P/N | Page 1 |
