Sony LCD Compatible Installation | Configuration and Connections |
|
|
|
|
Connecting System 4xi to Sony VPL-X2000U
[System 4xi model and software
versiondisplayed here]
(See note.)
(See note.)
(See note.)
(See note.) |
(Note: Information depends on System 4xi setup.)
If the System 4xi is already configured for a Sony LCD
1.Use the Front Panel to display the Information Menu to verify that the System 4xi is already set up for the Sony LCD projector. Apply power to the System 4xi and do the following:
a.Press to display the MENU SELECT on the LCD screen.
b.Press or to step to Menu 8.
c.Press to select this menu.
}d. Press or to display the configuration. The example to the left is general, yours will show the System 4xi model name, the software version and the following information:
PRJ = SONY
PRJ BAUD = 9600 UNIT No. = 000
HST BAUD = 9600 (value depends upon setup Menu 3)
2.Go to the procedure on page
Config | Model |
| SW1 | SW2 | SW3 | SW4 | SW5 | SW6 | PROJ | Comm | ||
|
|
|
|
|
|
|
|
| ||||
as | 1 | 2 | 3 | 4 |
|
|
|
|
| CABLE | Adapter | |
|
|
|
|
|
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
√ | Sony LCD | off | on | off | on | 0 | 0 | 3 | 5 | 1 | J15 |
SW2 |
SW6 |
SW4 |
SW3 |
SW5 |
J15
SW1
4 | 3 | 2 | 1 |
ON
3.
4.Install the System 4xi in its place of operation (i.e. rack), but not powered on.
__________ Changes in some switch configurations are not detected until the power is
removed at the AC cord, and then restored.
Refer to the following connection diagram and continue.
Extron • System 4xi Switcher Series • User’s Manual • P/N | Page 3 |