ADI: Advanced Distance Integration

TTL: Through the lens

•When [ADI flash] is selected, using a lens that is provided with a distance encoder feature can perform more accurate flash compensation by using more accurate distance information.

Notes

•When the distance between the subject and the external flash (not supplied) cannot be determined (wireless flash shooting using an external flash (not supplied), shooting with an off-camera flash using a cable, shooting with a macro twin flash, etc.), the camera automatically selects Pre-flash TTL mode.

•Select [Pre-flash TTL] in the following cases, as the camera cannot perform flash compensations with ADI flash.

–A wide panel is attached to the HVL-F36AM flash.

–A diffuser is used for flash shooting.

–A filter with an exposure factor, such as an ND filter, is used.

–A close-up lens is used.

•ADI flash is only available in combination with a lens that is provided with a distance encoder. To determine if the lens is equipped with a distance encoder, refer to the operating instructions supplied with the lens.

Selecting the method for measuring the brightness of a subject (Metering mode)

Fn button t[Metering mode] tSelect the desired mode

(Multi segment) This mode measures light on each area after dividing the total area into multiple areas and determines the proper exposure of the entire screen.

(Center weighted) While emphasizing the central area of the screen, this mode measures the average brightness of the entire screen.

(Spot)

This mode measures light only in the spot metering circle in

 

the center of the frame.

Shooting techniques

•Use (Multi segment) metering for general shooting.

•When shooting a subject with strong contrast in the focus area, measure the light of the subject you want to shoot with the proper exposure using Spot metering, then perform AE lock shooting (page 83).

function shooting the Using

89