Location and Function of Parts
Camera
Front
1 2 3
4 5 6
ALens
This is a
BTally lamp
Lights in red when a VISCA tally command is received or the camera is selected by the RM- BR300 Remote Control Unit (not supplied).
Flashes at intervals of about 0.5 seconds if the rotating speed of the cooling fan motor is lowered or the motor has stopped regardless of on/off of the tally lamp.
CRemote sensor
This is the sensor for the supplied Remote Commander.
When you use the upper remote sensor, set IMG- FLIP to ON in the SYSTEM menu (page 28). With this setting the remote sensor at the rear of the camera does not function.
DSONY and HD nameplates
Pull them out to turn them over and attach upside down if necessary.
EPOWER lamp
Lights when the camera is connected to an AC outlet using the supplied AC power adaptor and AC power cord.
Flashes in green when the camera receives an operation command from the supplied Remote Commander.
FSTANDBY lamp
Lights when the camera is turned off using the Remote Commander.
Rear
7 890qaqsqd
1 2 3 4 5 6 7 8 9 IR SELECT | R |
1OFF ON
2DATA MIX
| VISCA |
| OFF | ON EXT SYNC IN | |
! |
|
|
| 75 |
|
|
|
|
|
| |
DC IN 12V | IN VISCA | S VIDEO | VIDEO | RGB/COMPONENT |
qfqgqhqj qk ql
GDC IN 12V connector
Connect the supplied AC power adaptor.
HVISCA
For connection to the VISCA
IIR SELECT switch
Select the camera number when you operate multiple cameras with the same Remote Commander (page 33).
JRemote sensor
This is the sensor for the supplied Remote Commander.
This remote sensor does not function when IMG- FLIP is set to ON in the SYSTEM menu (page 28).
KDATA MIX switch
Set the switch to ON to overlap the menu with the video signal output from the installed Output Card. Set it to OFF not to overlap the menu.
L75-ohm termination switch
This switch is used when an external sync signal is used. Set it to OFF when this camera is in the middle of a daisy chain connection of multiple cameras. Set it to ON when the camera is at the end of a daisy chain connection or when nothing is connected to the EXT SYNC IN connector on the camera.
MEXT SYNC IN connector Accepts external video sync signals.
NVISCA RS-232C IN connector
Connect to the
Overview
Location and Function of Parts
13