Sony BRC-Z330 operating instructions Video OUT Menu, Display Info information display

IMG-FLIP to OFF, then turn the power off and on again, PAN REVERSE and TILT REVERSE will be set to OFF.

•If you set IMG-FLIP to ON, the remote sensor at the rear of the camera does not function.

DISPLAY INFO (information display)

When the camera settings are stored in POSITION 1 to 16 using the supplied Remote Commander or the RM- BR300 Remote Control Unit, the message “PRESET No. xx” automatically appears for 2 seconds on the monitor screen. If you want to display the message each time the camera is operated, set DISPLAY INFO to ON. Set it to OFF to cancel the display.

Note

The message will appear if the built-in cooling fan of the camera has accidentally stopped. When DISPLAY INFO is set to OFF, the display of this message is also canceled.

SYNC MASTER

When you connect a sync signal generator, you can select an output video signal that is synchronized with the external video sync signal input to the EXT SYNC IN connector on the camera from among the following output signals:

HD: Selects the output signal from the RGB/ COMPONENT connector on the camera.

SD: Selects the output signal from the VIDEO or S VIDEO connector on the camera.

H PHASE

When you connect a sync signal generator, adjust the horizontal phase so that the output signal is synchronized with the external sync signal input to the camera. The adjustable range is from 0 to 140.

When you select H PHASE on the menu, the message “PUSH ENTER BUTTON” appears on the screen. Press the HOME button on the Remote Commander or the button on the top of the joystick on the Remote Control Unit to make the color bars appear.

After completing the adjustment, press the HOME button on the Remote Commander or the button on the top of the joystick on the Remote Control Unit to make the color bar disappear.

VIDEO OUT Menu

<VIDEO OUT>

HD-RGB/COMPONENT

>FORMAT		YPBPR
SYNC TYPE			SYNC
SD-VIDEO/S	VIDEO
IMG SIZE	16:9[LETTER]
SETUP			OFF

HD-RGB/COMPONENT

FORMAT

Select the signal output from the RGB/ COMPONENT connector on the camera.

YPBPR: Outputs analog component signals.

RGB: Outputs RGB signals.

When you select a mode for FORMAT, some of the following setting items that are required for selected mode appear.

ADD SYNC: Specifies whether to add a sync signal. Setting the item to RGB specifies output of each R, G, and B signal with a sync signal added. Setting the item to OFF specifies output of each R, G, and B signal with no sync signal added.

SYNC TYPE: Specifies the type of sync signal. Setting

the item to SYNC specifies output of tri-level sync. Setting the item to VD specifies output of bi- level sync.

SD-VIDEO/S VIDEO

IMG SIZE

Select the aspect ratio of the signal output from the

VIDEO or S VIDEO connector on the camera.

16:9[LETTER]: The image is displayed in 16:9 letterbox.

4:3[CROP]: The image is displayed in 4:3 edge crop.

4:3[SQUEEZE]: The image is displayed in 4:3 squeeze.

SETUP

Select whether 7.5IRE setup is added to output signals.

ON: Outputs signals with 7.5IRE setup added.

OFF: Outputs signals with no 7.5IRE setup added.

Adjusting and Setting With Menus

VIDEO OUT Menu

29