Sony BRC-Z330 operating instructions Pan/Tilt and Zoom Operation, Panning and Tilting

Pan/Tilt and Zoom Operation

Panning and Tilting

POWER 1

direction of the camera while checking the picture on the screen. In such a case, press the 2 (REV) button while holding down the L/R DIRECTION SET button.

To reset the setting, press the 1 (STD) button while holding down the L/R DIRECTION SET button.

Arrow button Movement of the	Setting
camera
	L/R
	DIRECTION SET
	While holding down

CAMERA	SELECT		3	MANUAL
	2
1	FOCUS NEAR					BACK		LIGHT
AUTO	FAR
		SCREEN								3
							REV
	DATA								2
STD				STD
					1					5
								4
									PRESET

HOME

CAMERA SELECT

REV

6					2
RESET
POSITION	-TILT		-TILT		PAN-TILT
PAN			PAN
		HOME	RESET		RESET
			FAST
		SLOW	ZOOM	T
			T	W	-EV	100
			W		RM

STD

1

Press.

L/R

DIRECTION SET

While holding down

Operation Using the Supplied Remote Commander

L/R	SET
IRECTION
D

L/R DIRECTION

SET

1 Press the POWER switch.

The camera will turn on and perform the pan/tilt reset action automatically.

2 Press the arrow button to pan or tilt the camera. While checking the picture on the screen, press the desired arrow button.

To move the camera little by little, press the button just for a moment.

To move the camera in a wide range, press and

hold the button.

To move the camera diagonally, press the B or b button while holding down the V or v button.

When you perform a pan/tilt operation while the camera is in Telephoto mode, the movement speed will be decreased. If in Wide mode, the movement speed will be increased.

To face the camera back to the front

Press the HOME button.

If you accidentally move the camera with your hand

Press the PAN-TILT RESET button to perform the pan/ tilt reset action.

If the camera moves in a different direction from that you intended

The camera is preset to face toward the right whenever the b button is pressed. You might wish to face the camera toward the opposite direction from that of the button you pressed, for example, when you change the

REV

2

Press.

Note

The setting above only changes the signal emitted from the Remote Commander, and does not change the setting of the camera itself. Therefore, repeat the setting for each Remote Commander if you are using more than one Remote Commander.

If the STANDBY lamp of the camera flashes

When the camera is moved or turned by hand or by external shock, the microcomputer inside the camera may not be able to memorize the pan/tilt position properly and the camera may stop.

To reset the pan/tilt position, press the PAN-TILT RESET button or turn the power of the camera off and turn it on again.

STANDBY flashes

32

Pan/Tilt and Zoom Operation