Optimizing the recording condition
Use this feature to check the tape condition before recording, so that you can get the best possible picture (ORC).
(1) While the camcorder is in Standby mode, press MENU to display the menu.
(2) Turn the control dial to select ORC TO SET, then press the dial.
“START/STOP KEY” flashes.
(3) Press START/STOP.
The camcorder takes about 5 seconds to check the tape condition and then returns to Standby mode.
1 MENU | 2 |
| 1 |
| SEL/ |
| PUSH |
| EXEC |
MENU
WIND COMMANDER ORC TO SET REC MODE TITLE COL TITLE POS TITLE1 SET
[MENU]: END
2
SEL/ PUSH EXEC
START/STOP
KEY
3
| CK |
|
| O |
|
L |
| |
S |
| ORC |
T |
|
|
A |
|
|
N |
|
|
D |
| |
| BY |
|
START/STOP |
| |
STBY 0:00:00
Each time you insert the cassette
Perform the above procedures.
To see if the tape condition has been checked
If the ORC indicator lights up in the display window, the tape condition has been checked.
Notes on the ORC function
•When you set ORC TO SET, the recording on the tape is erased for about 0.1 second so that the camcorder can check the tape condition. Be careful when you use a recorded tape. The 0.1 second blank is erased if you record from the point where you set ORC TO SET for more than 2 seconds, or if you record over the blank.
•You cannot use this function on a tape with the red mark on the cassette exposed.
46