Sony CD-X1500 owner manual Fader Start, Relay Play, Auto Cue, Auto Ready

3.When track memory number is shown in the LCD, pressing the ENT key recalls the track from the track memory number.

NOTE

…Cue and loop points can be memorized and/or recalled. However, just after the recall operation, seamless start from the cue or loop points cannot be performed because there are no data in the RAM buffer just after the recall operation. Once playing from cue points (CUE 1-3) and/or loop start point for a few second, flash start and/or seamless looping can be performed.

4-6. Fader Start

Connect the FADER START jack on the rear panel of the main unit and fader start jack on the external device which supports the fader start function (i.e.

X-9, X-17, X-15, XS-3, etc…) with the fader start cable which is supplied to perform fader start/back

cue performance with external device.

Audio signal should be connected to the external device as well.

TIP: Start (low active, more than 50ms)

GND: Back cue (low active, more than 50ms)

4-7. Relay Play

Turning on the Relay play function either left or right unit turns on the relay play function. When relay play is activated, when left unit finishes playback, right unit will start playback and vice versa automatically.

Pressing and holding the SHIFT key then pressing the BRAKE key turns the relay play function on and off. When relay play is turned on, the “RELAY” indicator in the LCD lights.

4-8. Auto Cue

Auto cue function allows the unit to search the beginning of the song and pause there automatically. The detection level is fixed to –54dB. When Auto cue function is turned on, “A.CUE” indicator in the LCD lights.

Pressing and holding the SHIFT key then pressing the BEND – key turns the AUTO CUE function on and off.

4-9. Auto Ready

Auto Ready function allows the unit to pause the beginning of the next track when playback of the current track is finished.

The behavior of Auto Ready function is follows.

Continuous play mode:

Pause the beginning of the next track when playback of the current track is finished.

Single play mode:

Pause the beginning of the current track when playback of the current track is finished.

Program play mode:

Pause the beginning of the next programmed track when playback of the current track is finished.

When Auto Ready function is turned on, “A.RDY” indicator in the LCD lights.

Pressing and holding the SHIFT key then pressing

the BEND + key turns the AUTO READY function on and off.

TASCAM CD-X1500 DUAL CD PLAYER 17