Normally, with the DSP mode on, the volume of the output sound from the rear speakers is lowered automatically to improve the efficiency of the listening position setting. If you want to raise the rear speaker volume, adjust the fader.
1 Follow steps 1 through 3 of “Selecting a surround menu” (page 26).
2 Press (SOUND) repeatedly until “FAD” appears.
3 Rotate the dial to adjust the fader.
Decreases front speaker volume
Increases front speaker volume
After three seconds, the display goes back to normal playback mode.
Adjusting the volume of the subwoofer(s)1 Press (SOURCE) to select a source (tuner,
CD or MD).
2 Press (SOUND) repeatedly until “SUB” appears.
3 Rotate the dial to adjust the volume.
After three seconds, the display goes back to normal playback mode.
Tip
When you rotate the dial to turn the volume all the way down, “Sub ATT” appears and the
Adjusting the frequency of the subwoofer(s)
To match the characteristics of the connected subwoofer(s), you can cut out the unwanted high and middle frequency signals entering the subwoofer(s). By setting the
Level |
62 78 99 125 157 198 Frequency (Hz)
1 Press (SOURCE) to select a source (tuner,
CD or MD).
2 Press (SOUND) for two seconds.
3 Press (SOUND) repeatedly until “SUB” appears.
4 Rotate the dial to select the desired cutoff frequency.
The
62 n78 n99 n125* n157 n198 Hz
*
5 Press (SOUND) for two seconds.
After the frequency setting is complete, the display goes back to normal playback mode.
EN
DSP
29