The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures.
General
Problem | Cause/Solution |
|
|
No sound. | •Cancel the ATT function. |
| •Set the fader control to the center position for |
| systems. |
| •Rotate the dial in a clockwise direction to adjust the volume. |
|
|
The contents of the memory | • The power cord or battery has been disconnected. |
have been erased. | • The reset button has been pressed. |
| nStore again into the memory. |
Indications do not appear in the Remove the front panel and clean the connectors. See “Cleaning
display.the connectors” (page 34) for details.
CD/MD playback
Problem | Cause/Solution |
|
|
A disc cannot be loaded. | •Another CD is already loaded. |
| •The CD is forcibly inserted upside down or in the wrong way |
| (MD). |
|
|
Playback does not begin. | Defective MD or dusty CD. |
|
|
A disc is automatically ejected. | The ambient temperature exceeds 50°C (122°F). |
|
|
The operation buttons do not | Press the reset button. |
function. |
|
|
|
The sound skips due to | • The unit is installed at an angle of more than 60°. |
vibration. | • The unit is not installed in a sturdy part of the car. |
|
|
Radio reception
Problem | Cause/Solution |
Preset tuning is not possible. | • Memorize the correct frequency. |
| • The broadcast signal is too weak. |
|
|
Automatic tuning is not | The broadcast signal is too weak. |
possible. | nUse manual tuning. |
|
|
The “ST” indication flashes. | •Tune in the frequency accurately. |
| •The broadcast signal is too weak. |
| nSet to the MONO mode (page 14). |
|
|
Interference occurs during FM | The Wide mode is selected. |
reception. | nSet to Narrow or IF Auto mode (page 14). |
|
|
EN
Information Additional
37