Sony CDX-M60UI Storing and receiving stations, Radio, Caution, Storing manually, Tuning automatically, Storing automatically — BTM, Receiving the stored stations, (1), (6)

1Press (ZAP) during playback.

After “ZAPPIN” appears in the display, playback starts from a passage of the next track.

The passage is played for the set time, then a click sounds and the next passage starts.

Track

1 2 3 4

ZAP

The part of each track to playback in ZAPPIN mode.

2Press the select button or (ZAP) when a track you want to listen is played back.

The track that you select returns to normal play mode from the beginning.To search a track by ZAPPIN mode again, repeat steps 1 and 2.

Tips

•You can select the playback time from about 6 seconds/9 seconds/30 seconds (page 17).You cannot select the passage of the track to playback.

•Press (SEEK) –/+ or (1)/(2) (ALBUM –/+) in ZAPPIN mode to skip a track or album.

•Pressing (BACK) also confirms a track to playback.

Radio

Storing and receiving stations

Caution

When tuning in stations while driving, use Best Tuning Memory (BTM) to prevent an accident.

Storing automatically — BTM1Press (SOURCE) repeatedly until “TUNER” appears.

To change the band, press (MODE) repeatedly. You can select from FM1, FM2, FM3, AM1 or AM2.

2Press and hold (BTM) until “BTM” flashes.The unit stores stations in order of frequency on the number buttons.A beep sounds when the setting is stored.Storing manually

1While receiving the station that you want to store, press and hold a number button ((1) to (6)) until “MEM” appears.

Note

If you try to store another station on the same number button, the previously stored station will be replaced.

Receiving the stored stations1Select the band, then press a number button ((1) to (6)).Tuning automatically1Select the band, then press (SEEK) +/– to search for the station.

Scanning stops when the unit receives a station. Repeat this procedure until the desired station is received.

Tip

If you know the frequency of the station you want to listen to, press and hold (SEEK) +/– to locate the approximate frequency, then press (SEEK) +/– repeatedly to fine adjust to the desired frequency (manual tuning).

11