You can adjust the balance, fader, and subwoofer volume.
1Press (SEL) repeatedly until “BAL,” “FAD” or “SUB” appears.
The item changes as follows:
LOW*1 t MID*1 t HI*1 t
BAL
*1 When EQ3 is activated (page 9).
*2 When the audio output is set to “SUB” (page 9). “ATT” is displayed at the lowest setting, and can be adjusted up to 20 steps.
2Press the volume +/– button repeatedly to adjust the selected item.
After 3 seconds, the setting is complete and the display returns to normal play/reception mode.
With the card remote commander
In step 2, to adjust the selected item, press <, M, , or m.
Customizing the equalizer curve— EQ3“CUSTOM” of EQ3 allows you to make your own equalizer settings.
1Select a source, then press (EQ3) repeatedly to select “CUSTOM.”
2Press (SEL) repeatedly until “LOW,” “MID” or “HI” appears.
3Press the volume +/– button repeatedly to adjust the selected item.
The volume level is adjustable in 1 dB steps, from
Repeat steps 2 and 3 to adjust the equalizer curve.
To restore the
After 3 seconds, the setting is complete and the display returns to normal play/reception mode.
Tip
Other equalizer types are also adjustable.
With the card remote commander
In step 3, to adjust the selected item, press <, M, , or m.
Adjusting setup items — SET1Press and hold (SEL).
The setup display appears.
2Press (SEL) repeatedly until the desired item appears.
3Press the volume +/– button to select the setting (example “ON” or “OFF”).
4Press and hold (SEL).
The setup is complete and the display returns to normal play/reception mode.
Note
Displayed items will differ, depending on the source and setting.
With the card remote commander
In step 2, to select the setup item, press M or m. In step 3, to select the setting, press < or ,.
The following items can be set (follow the page reference for details):
“z” indicates the default settings.
CT (Clock Time)
To set
BEEP
To set
SUB/REAR*1
To switch the audio output.
–“SUB” (z): to output to a subwoofer.
–“REAR”: to output to a power amplifier.
DIM (Dimmer)
To change the brightness of the display.
–
–
DEMO*1 (Demonstration)
To set
A.SCRL (Auto Scroll)
To scroll long displayed item automatically when the group/track is changed.
–
–
REG*2 (Regional)
To set
LPF*3 (Low Pass Filter)
To select the subwoofer
*1 When the unit is turned off.
*2 When FM is received.
*3 When the audio output is set to “SUB.”
9