Sony CDX-S2200 Additional Information, Maintenance, Adjusting the equalizer curve

Adjusting the equalizer curve

You can store and adjust the equalizer settings for different tone ranges.

1 Press (SOURCE) to select a source (Radio or CD).

2 Press (EQ3) repeatedly to select the desired equalizer curve.

3 Adjusting the equalizer curve.

1Press (SEL) repeatedly to select the desired tone range.

Each time you press (SEL), the tone range changes.

LOW t MID t HI (t BAL t FAD)

2Press the volume +/– button repeatedly to adjust to the desired volume level.

The volume level is adjustable by 1 dB steps from –10 dB to +10 dB.

3Repeat step 1 and 2 to adjust the equalizer curve.

To restore the factory-set equalizer curve, press (SEL) for 2 seconds.

Note

When EQ3 is set to “OFF,” you cannot adjust the equalizer curve settings.

Additional Information

Maintenance

Fuse replacement

When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case, consult your nearest Sony dealer.

Fuse (10 A)

Warning

Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit.

Cleaning the connectors

The unit may not function properly if the connectors between the unit and the front panel are not clean. In order to prevent this, detach the front panel (page 9) and clean the connectors with a cotton swab dipped in alcohol. Do not apply too much force. Otherwise, the connectors may be damaged.

Main unit

Back of the front panel

Notes

•For safety, turn off the ignition before cleaning the connectors, and remove the key from the ignition switch.

•Never touch the connectors directly with your fingers or with any metal device.

continue to next page t 21