Table of Contents
Introduction | 3 | Power Saving Function | 7 |
Precautions | 3 | Plug and Play | 8 |
Getting Started | 4 | Use of the | 8 |
Using Your Monitor | 4 | Damper Wire | 8 |
Adjustments | 5 | Specifications | 8 |
Entering New Timings | 7 | Troubleshooting | 9 |
Introduction
Congratulations on your purchase of a Sony Multiscan 15sfII/17sfII!
This monitor incorporates over 25 years of Sony experience with Trinitron display technology, ensuring excellent performance and outstanding reliability. The Multiscan 15sfII/17sfII’s wide scan range (31 – 65 kHz), together with Digital Multiscan Technology, allows it to sync to any video mode from standard VGA through 1024 × 768 at 76 Hz (1280 × 1024 at 60 Hz).
In addition, its two factory preset color modes and one user adjustable color mode give you unprecedented flexibility in matching
Furthermore, the Multiscan 15sfII/17sfII feature digital controls, raster rotation, power saving, low emissions, and much more. All together, it delivers incredible performance with the quality and support you can expect from Sony.
Precautions
InstallationMaintenance
EN
∙Prevent internal heat
∙Do not install the unit near heat sources such as radiators or air ducts, nor in a place subject to direct sunlight, excessive dust, mechanical vibration or shock.
∙Do not place the unit near equipment which generates magnetism, such as a converter or high voltage power lines.
∙Clean the cabinet, glass panel and controls with a soft cloth lightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent, such as alcohol or benzine.
∙Do not rub, touch, or tap the surface of the screen with sharp or abrasive items, like a ball point pen or a screw driver. Otherwise, this type of contact may result in a scratched picture tube.
Warning on Power Connection
∙Use the supplied power cord.
For the customers in U.S.A.
If you do not do this, this monitor will not conform to mandatory FCC standards.
for 100 to 120 V AC | for 220 to 240 V AC |
∙Before disconnecting the power cord, wait for at least
30 seconds after turning off the power switch to allow for the discharging of static electricity on the CRT display surface.
∙After the power has been turned on, the CRT is demagnetized for approximately 5 seconds. This generates a strong magnetic field around the bezel which may affect the data stored on magnetic tape or disks near the bezel. Place such magnetic recording equipment and tapes/disks at a distance from this unit.
The
3
