Sony CPD-15SF2 manual Entering New Timings, Power Saving Function, Setteing the color temperature

Setteing the color temperature

The selected color temperature becomes the common setting for all input signals.

1 Press COLOR button.

The “COLOR TEMPERATURE” OSD appears.

COLOR	COLOR TEMPERATURE
	VAR I ABLE
	5000K 9300K
	50

2 Adjust with the ¬ ?//and > >/.buttons.

To select 5000K or 9300K Press ¬ ?//buttons.

The selected color temperature is indicated in yellow.

?. . . to select 5000K /. . . to select 9300K

To obtain the desired color temperature between 5000K and 9300K

Press > >/.buttons.

>. . . for higher temperature

.. . . for lower temperature

Your most recent adjusted color temperature will be recalled by pressing > >/.button.

To erase the “COLOR TEMPERATURE” OSD, press the COLOR button again.

The “COLOR TEMPERATURE” OSD automatically disappears 20 seconds after you release the buttons.

Resetting

∙Press the RESET button to recall the factory settings for brightness, contrast, horizontal and vertical size, center and pincushion for the mode currently in use.

∙Press and hold the RESET button for 2 seconds to recall factory setting for all adjustments in all modes.

RESET

Entering New Timings

When using a video mode that is not one of the 6 factory preset modes, some fine tuning may be required to optimize the display to your preferences. Simply adjust the monitor according to the preceding adjustment instructions. The adjustments will be stored automatically and recalled whenever that mode is used.

A total of 10 user-defined modes can be stored in memory. If the 11th mode is entered, it will replace the first.

Power Saving Function

This monitor meets the power saving guidelines set by the EPA Energy Star Program as well as the more stringent NUTEK 803299 (TCO92) guidelines. It is capable of reduced power consumption when used with a computer equipped with Display Power Management Signaling (DPMS). By sensing the absence of the sync signal coming from the computer, it will reduce the power consumption as follows:

CAUTION: The Power Saving function will automatically put the monitor into Active-off state if the power switch is turned on without any video signal input. Once the horizontal and vertical syncs are sensed, the monitor will automatically return to its Normal operation state.

EN

	State	Power	Required	uPower	POWER
		consumption	resumption	indicator	SAVING
			time		indicator
1	Normal	100%	—	green on	off
	operation
	Suspend	approx.	approx.	green on	orange on
2	(1st step of
		10%	3 sec.
	power saving)
	Active-off	CPD-15SF2:
		approx. 7%	approx.
3	(2nd step of			off	orange on
		CPD-17SF2:	10 sec.
	power saving)
		approx. 6%

7