
The station plate will sink in when it is slid all the way to the correct position. You will hear a click when the plate is attached properly.
If the station plate does not sink in properly, evenly push down on its left/right sides.
The positioning marker A on the station plate and positioning marker on the



AC Power cord (mains lead)
To a wall outlet (wall socket)
Detach the protection cover of the I/O unit. Before you place a camera on the
Hold the
3 Connect the supplied AC Adaptor to the DC IN jack of the
You can use the
Use a commercially available AC plug adaptor, if necessary, depending on the design of the wall outlet (wall socket).
AC plug adaptor (not supplied)
Do not use an electronic transformer (travel converter), as this may cause a malfunction.
Preparing the Remote CommanderNotes on the Remote CommanderThe Remote Commander is powered by a button type lithium battery (CR2025) installed at the factory. An insulation sheet is inserted to avoid the battery exhaustion. Remove the insulation sheet before using the Remote Commander for the first time.
Insulation sheet

Point the remote sensor of the