The Remote Commander range is less than five meters (for indoor use). Point the Remote Commander at the remote sensor of the Cyber- shot Station. Try adjusting the angle of the Remote Commander if you cannot operate the Cyber-shot Station.

Placing the camera on the Cyber-shot Station

Remove the Adaptor ring, the Conversion lens, etc. from the camera.Attach the camera as shown below.Be sure to turn off the camera before placing it on the Cyber-shot Station.When attaching the camera, make sure to insert the camera straight down.TipsMake sure that the camera is securely attached to the Cyber-shot Station.
Removing the camera from the Cyber-shot Station

Hold the Cyber-shot Station down when you remove the camera from the Cyber-shot Station.

Notes

When removing the camera, make sure to lift the camera straight up. It may damage the camera or the Cyber-shot Station when some extra force is added to the front or the sides.

Charging the battery pack

Place the camera with the battery pack inserted on the Cyber-shot Station.

Charging starts automatically. The CHARGE lamp of the Cyber-shot Station lights up.

When the camera is turned on, the Cyber-shot Station cannot charge the battery pack.

When the charging reaches to Normal charge*, the CHARGE lamp goes off.

*Recording and playback time with Normal charge is approximately 90% of Full charge.

For the time of the full charge for a completely discharged battery at the temperature of 25 °C (77 °F), see the table below.

DSC-T300/T75/T70/T2Approx.

 

160 minutes
DSC-

Approx.

W300/W170/W150//W130/
230 minutes
W125/W120/W115/W110

 

It may take longer to charge, depending on the charging condition and environment.

14-GB