3 Use the control buttons on the Remote Commander to select the search condition and press the center button.

The images are displayed in index mode in accordance with the search condition.

For further information, refer to the operating instructions supplied with the camera.

Switching between HD and SD

You can switch the TV display between high- definition video (HD) and other than high- definition video (SD) by pressing the HD/SD button on the Remote Commander.

Except for DSC-T75/T70/T2.

1 Turn on the power of the camera by pressing the (playback) button of the camera or the POWER button on the Remote Commander.

2 Press the HD/SD button on the Remote Commander.

Every time you press the HD/SD button, the setting will change alternately between HD and SD.

The HD-OUTPUT lamp (blue) of the Cyber-shot Station lights up while the HD video is viewed on a TV.

For further information, refer to the operating instructions supplied with the camera.

Wide Zoom Display

You can display a still image with an angle of view of 4:3 or 3:2 to those of 16:9 by pressing the W ZOOM button on the Remote Commander, which is the same as the wide zoom function of the camera.

For DSC-T75/T70, the Wide Zoom functionswhen you press the button on the Remote Commander.Except for DSC-T2.

1 Turn on the power of the camera by pressing the (playback) button of the camera or the POWER button on the Remote Commander.

2 Press the W ZOOM button on the Remote Commander.

Every time you press the W ZOOM button, the setting will change alternately between Wide Zoom and Normal modes.

The Wide Zoom mode is canceled when you turn off the camera or the shooting mode is switched.

Some functions of the Remote Commander will be unavailable when you are using the Wide Zoom function.

For further information, refer to the operating instructions supplied with the camera.

Care and maintenance

Clean the Cyber-shot Station with a soft cloth slightly moistened with water or tepid water, and wipe the surface with a dry cloth. Do not use any type of solvent such as thinner, alcohol or benzine as this may damage the surface.

Changing the battery of the Remote Commander

WARNING 

Battery may explode if mistreated. Do not recharge, disassemble, or dispose of in fire.

When the lithium battery becomes weak, the operating distance of the Remote Commander may shorten, or the Remote Commander may not function properly. In this case, replace the battery with a Sony CR2025 lithium battery. Use of another battery may present a risk of fire or explosion.

For the State of California, USA only

Perchlorate Material - special handling may apply, See www.dtsc.ca.gov/hazardouswaste/perchlorate Perchlorate Material: Lithium battery contains perchlorate.

CAUTION

Replace the battery with the specified type only. Otherwise, fire or injury may result.

Replacing the button type lithium battery*Do not use any batteries other than CR2025.Pull out the battery holder while pushing the tab on the holder.Put a new battery into the holder with its + side facing upward.Insert the holder into the Remote Commander until it clicks.tab 17-GB