Getting Started – BASIC –

9 Connect the calibration mic to the ECM-AC2 jack on the rear of the control unit, and set it up at the ear level using a tripod, etc. (not supplied).

The front of each speaker should face the calibration mic, and there should be no obstruction between the speakers and the calibration mic.

Note

•The ECM-AC2 jack is used for the supplied calibration mic only. Do not connect other microphones.

Rear of the control unit

To ECM-AC2 jack

Calibration mic

10 Press X/x to select [YES], then press

.

[AUTO CALIBRATION] starts. Be quiet during the measurement.

Note

•Loud test sound is output when [AUTO CALIBRATION] starts. You cannot turn the

volume down. Give consideration to children and neighbor.

•Avoid being in the measurement area and making noise during the measurement (which takes about 1 minute), as it may interfere with measurement.

11 Unplug the calibration mic and press C/cto select [YES].

Measurement complete.

 

 

FRONT L :

16ft

4.87m

0.0dB

FRONT R :

16ft

4.87m

0.0dB

CENTER :

16ft

4.87m

+ 1.0dB

SUBWOOFER :

16ft

4.87m

+ 4.0dB

SURROUND L :

10ft

3.04m

- 2.0dB

SURROUND R :

10ft

3.04m

- 2.0dB

If OK, unplug calibration mic and select

“YES”.

YES

NO

 

Note

•The environment of the room in which the system is installed may affect measurements.

•If measurement fails, follow the message then retry [AUTO CALIBRATION].

12 Press .

Quick Setup is finished. All connections and setup operations are complete.

To quit the Quick Setup

Press DISPLAY in any Step.

Tip

•If you cancel [AUTO CALIBRATION], perform the speaker settings in “Settings for the Speakers” (page 92).

•If you change the position of the speakers, reset the speaker settings. See “Calibrating the Appropriate Settings Automatically” (page 83).

•If you want to change any of the settings, see “Using the Setup Display” (page 86).

•For details on [AUTO CALIBRATION] and the error messages of [AUTO CALIBRATION], see “Calibrating the Appropriate Settings Automatically” (page 83).

20US