Connecting your camcorder to your computer using the USB cable (For Windows users)

If you cannot install the USBdriver

The USB driver has been registered incorrectly as your computer was connected to your camcorder before installation of the USB driver was completed. Perform the following procedure to correctly install the USB driver.

Viewing images recorded on a tape

Step 1: Uninstall the incorrect USB driver

1Turn on your computer and allow Windows to load.

2Connect the AC power adaptor, and set the POWER switch to VCR.

3Connect the USB connector on your computer

to the (USB) jack on your camcorder using the USB cable supplied with your camcorder.

4Open your computer’s “Device Manager”.

Windows XP:

Select “Start” t “Control Panel” t “System” t “Hardware”, and click the “Device Manager” button.

If there is no “System” inside “Pick a category” after clicking “Control Panel”, click “Switch to classic view” instead.

Windows 2000 Professional:

Select “My Computer” t “Control Panel” t “System” t “Hardware” tab, and click the “Device Manager” button.

Windows 98SE/Windows Me:

Select “My Computer” t “Control Panel” t “System”, and click “Device Manager”.

De camcorder aansluiten op uw computer via de USB-kabel (voor Windows gebruikers)

Als het installeren van het USBstuurprogramma niet lukt

Soms wordt is het USB stuurprogramma niet juist geregistreerd, omdat uw computer al werd aangesloten op de camcorder voordat de installatie van het USB stuurprogramma was voltooid. Volg de onderstaande aanwijzingen om het USB stuurprogramma opnieuw te installeren.

Bandopnamen weergeven via uw computerStap 1: Het onjuist geïnstalleerde USB stuurprogramma verwijderen

1Schakel uw computer in en wacht totdat

Windows gestart is.

2Sluit de netspanningsadapter aan op uw camcorder en zet de POWER schakelaar in de

“VCR” stand.

3Verbind de USB-aansluitbus van uw

computer met de USB-aansluitbus van uw camcorder, met behulp van de bij uw camcorder geleverde USB-kabel.

4Open het onderdeel “Apparaatbeheer” van uw computer.

Voor Windows XP

Stel in op “Start” t “Configuratiescherm” t “Systeem” t “Hardware” (apparatuur) tabblad en klik dan op de “Apparaatbeheer” knop.

Als de aanduiding “Systeem” niet verschijnt onder “Kies een categorie” nadat u geklikt hebt op “Configuratiescherm”, klik dan op “Overschakelen naar klassieke aanblik”.

Voor Windows 2000 Professional:

Stel in op “Deze computer” t “Configuratiescherm” t “Systeem” t “Hardware” (apparatuur) tabblad en klik dan op de “Apparaatbeheer” knop.

Voor Windows 98 Tweede editie/Windows Me:

Stel in op “Deze computer” t “Configuratiescherm” t “Systeem” en klik dan op “Apparaatbeheer”.

206