Settings | For details on the operation 1 page 54 |
For [Connection], [SSID], [Encryption], and [Password], set them up according to your access point.
5When setting up DHCP (Dynamic Host Configuration Protocol), select [Advanced], then press z. The advanced setup screen appears.
6Set up the following items, select [Save], then press z.
[IP Address], [Subnet Mask], [Default Gateway], [Primary DNS], [Secondary DNS]
•For details on the connection method, refer to the operating instructions supplied with your wireless LAN access point.
7Select [Save], then press z.
The registered information is displayed.
8Select [Exit], then press z.
To perform a connection testSelect [Test] in step 8, then press z.
To edit an access point1Select the access point you want to edit in Step 2, then press MENU.
2Select [Edit], then press z. Follow the process again from Step 4.
To delete an access point1Select the access point you want to delete in Step 2, then press MENU.
2Select [Delete], then press z.
Network Power SaveThis function reduces power consumption when the device is connected to the network.
| On | Automatically reduces power consumption while the data is |
|
| not sent/received. |
|
|
|
| Off | Does not use the Network Power Save function. |
|
|
|
•Set to [Off] in the following cases:
–When an access point cannot be connected.
–When there is a problem with the network connection.
NicknameSpecifies a nickname for your camera. This nickname is shown on the other cameras in a wireless connection.
See page 90.
settings the Changing
71