Adjusting the recording sound

To attenuate the recording level

Attenuate the recording level when recording very loud sounds. •When using the built-in microphone or external microphone.

Set the MIC switch to ATT. Normally set off (green position).

•When connecting an external microphone to AUDIO IN (CH-1/CH-2) input connector.

Set ATT (REAR) to ON.

To reduce wind noise of the built-in microphone

If there is a loud wind, set the BUILT-IN MIC switch to WIND. Note that low frequency input signal will weaken.

To change the directionality of the built-in microphone

Set DIRECTION SELECT to the desired position (0°/90°/120°).

When set to 0° the sound is in monaural.

MIC (PLUG IN POWER)

DIRECTION SELECT

MIC

BUILT-IN MIC

AUDIO IN

CH-1 LINE/MIC

 

CH-1 ATT (REAR)

CH-2 LINE/MIC

CH-2 ATT (REAR)

operations Advanced

67