2+1 Channel Surround Hookups
Started Getting
This connection is for listening to the sound through the left and right speakers of the TV, or speakers connected to a receiver and the subwoofer. You can enjoy rich bass frequencies by connecting a subwoofer. Refer to the instructions supplied with the component to be connected.
Set “SUBWOOFER” in “SPEAKER SETUP” to “YES” in the setup display (page 76). Then set “FRONT SPEAKER SIZE” to “TV” when you use the TV’s speakers, or to “LARGE,” “MIDDLE” or “SMALL” when you use the speakers connected to the receiver.
zYou can enjoy surround sounds even if you connect front speakers only
You can use 3D sound imaging to create virtual rear speakers from the sound of the front speakers (L, R) without using actual rear speakers (VES: Virtual Enhanced Surround). For details, see page 51.
CD/DVD player
Required cords
Audio connecting cord (not supplied) (1)
White (L) | White (L) |
Red (R) | Red (R) |
S video cord (supplied) (1)
When connecting the cords, be sure to match the
Monaural audio cord (not supplied) (1)
One for a subwoofer
|
| L |
| L |
To |
| R |
| R |
|
|
| COAXIAL OPTICAL | |
|
|
| PCM/DTS/MPEG/ | |
WOOFER OUT |
|
|
| DOLBY DIGITAL |
WOOFER OUT AUDIO OUT | AUDIO IN DIGITAL OUT | |||
T |
|
| i | |
VIDEO | S VIDEO | COMPONENT | MEGA | |
OUTPUT | OUTPUT | VIDEO OUT | CONTROL | |
|
| Y CB | CR |
|
To S VIDEO | To AUDIO | To mains |
OUTPUT | OUT (R, L) | |
|
| Receiver (Amplifier) |
| To audio input | CD |
|
| |
|
| L |
|
| R |
Subwoofer | or | TV |
(Active type) |
| INPUT |
| To audio input | VIDEO |
INPUT | S | |
|
| L |
|
| AUDIO |
|
| R |
To S VIDEO input
: Signal flow
Note
You cannot enjoy the picture with S video signal if your TV does not conform to the S video signal. When your TV does not have an S VIDEO input, connect the component via the VIDEO INPUT connector using the video connecting cord (not supplied) instead of the S video cord. For details, see page 9.
Refer to the instructions supplied with your TV.
14