Getting
Started
This section describes how to hook up the CD/DVD player to a TV (with audio/video input jacks) and/or an AV receiver (amplifier). You cannot connect this player to a TV which does not have a video input connector. Be sure to turn off the power of each component before making the connections.
Unpacking
Check that you have the following items:
•Audio/video connecting cord (1)
•S video cord (1)
•Remote commander (remote)
•R6 (size AA) batteries (2)
Inserting batteries into the remote
You can control the player using the supplied remote. Insert two R6 (size AA) batteries by matching the + and – ends on the batteries to the markings inside the compartment. When using the remote, point it at the remote sensor on the player.
zYou can control TVs and AV receivers (amplifiers) using the supplied remote
See page 77.
Notes
•Do not leave the remote in an extremely hot or humid place.
•Do not drop any foreign object into the remote casing, particularly when replacing the batteries.
•Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.
•If you do not use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.
Transporting the player
Before transporting the player, follow the procedure below to return the internal mechanisms to their original positions.
1Remove all the discs from the disc slots.
Failure to remove the discs may cause damage to the player.
2Press OPEN/CLOSE to close the front cover.
Make sure that “NO DISC” appears on the front panel display.
3Wait for 10 seconds, then press ?/ 1 on the remote, followed by! on the player.
This will safely turn off the player.
Started Getting
7