Sony DVP-NC80V Press X/x to select the setting that matches your TV type, 11Press Enter

7 Press X/x to select the setting that matches your TV type.

◆If you have a 4:3 standard TV

•4:3 LETTER BOX or 4:3 PAN SCAN (page 67)

◆If you have a wide-screen TV or a 4:3 standard TV with a wide-screen mode

• 16:9 (page 67)

8 Press ENTER.

The Setup Display for selecting the type of jack used to connect your amplifier (receiver) appears.

Is this player connected to an amplifier (receiver)? Select the type of jack you are using.

YES

LINE OUTPUT L/R(AUDIO)

DIGITAL OUTPUT

DIGITAL & 5.1CH OUTPUT

NO

9 Press X/x to select the type of jack (if any) you are using to connect to an amplifier (receiver), then press

ENTER.

If you did not connect an AV amplifier (receiver), select “NO.” Quick Setup is finished and connections are complete. If you connected an AV amplifier (receiver) using just an audio cord, select “YES: LINE OUTPUT L/R (AUDIO).” Quick Setup is finished and connections are complete.

If you connected an AV amplifier (receiver) using a digital coaxial or optical cord, select “YES: DIGITAL OUTPUT.” Setup Display for “DOLBY DIGITAL” appears.

If you connected an AV amplifier (receiver) using an audio cord, select “YES : DIGITAL & 5.1CH OUTPUT.” The Setup Display for “DOLBY DIGITAL” appears.

10Press X/x to select the type of

Dolby Digital signal you wish to send to your amplifier (receiver).

If your AV amplifier (receiver) has a Dolby Digital decoder, select “DOLBY DIGITAL.” Otherwise, select “D-PCM.”

AUDIO SETUP

AUDIO ATT:		OFF
AUDIO DRC:		STANDARD
AUDIO FILTER:		SHARP
DOWNMIX:	DOLBY SURROUND
DIGITAL OUT:		ON
DOLBY DIGITAL:		D-PCM
DTS:		D-PCM

48kHz/96kHz PCM: DOLBY DIGITAL

11Press ENTER.

“DTS” is selected.

AUDIO SETUP

AUDIO ATT:			OFF
AUDIO DRC:		STANDARD
AUDIO FILTER:			SHARP
DOWNMIX:	DOLBY SURROUND
DIGITAL OUT:			ON
DOLBY DIGITAL:			D-PCM
DTS:			D-PCM
48kHz/96kHz PCM:			D-PCM
			DTS

12Press X/x to select whether or not you wish to send a DTS signal to your amplifier (receiver).

•If your AV amplifier (receiver) has a DTS decoder, select “DTS.” Otherwise, select “D-PCM.”

13Press ENTER.

◆When “DIGITAL OUTPUT” is selected in step 9

• Quick Setup is finished and connections are complete.

◆When “DIGITAL & 5.1CH OUTPUT” is selected in step 9

• The Setup Display for “SPEAKER SETUP” appears.

14Press X/x to select the size of the center speaker.

If no center speaker is connected, select “NONE” (page 71).

SPEAKER SETUP

SIZE:
DISTANCE:
LEVEL(FRONT):
LEVEL(REAR):	OFF
TEST TONE:
FRONT:	LARGE

CENTER:SMALL

REAR:NONE

SUBWOOFER:YES

24