2-2 DXC-190
2-3. Compensation of Residual PointNoise
Description:
If an accrued white dot (Residual Point Noise) of the CCD
is visible, compensate it.
However, the compensation is limited up to two points.
Tools Required:
Remote Commander, RM-95 : J-6082-053-B 1pc
Board for Interface Tool : J-6430-530-A 1pc
Procedure:
1. Connect the service tool to a camera. And turn on the
camera.
2. Set the camera to AGC TURBO and close the lens.
3. Press the FOCUS key on the remote commander to
enter into the compensation set mode.
4. When the marker does not appear on a screen, align
the X-axis of coordinate with 00 with the FF key.
5. When the marker does not still appear, align the Y-axis
of coordinate with 00 with the PLAY key.
6.
If the marker still does not appear, repeat steps 3 and 4.
7. Align the marker with a point to be compensated by
pressing PLAY, STOP, REW or FF key. At this
moment, the marker numbers shown below appear on
the LCD. The marker number (from left to right) X-
axis of coordinate : lower 2 digits, Y-axis of coordi-
nate : lower 2 digits
8. Press the FOCUS key to confirm that the point is
compensated.
9. If not compensated, press the FOCUS key and repeat
steps 6 and 7.
10. In case that there are two points to be compensated,
press the FOCUS key first and then the REC REVIEW
key to switch the marker. And repeat steps 6 and 7.
11. After completion of compensation, turn on the camera
and confirm that the desired points are compensated. If
not, repeat steps 1 through 11.
Table : Key Map of RM-95
KEY Function
FOCUS Compensation Set Mode Switch
REC REVIEW Switch-over of Setting
PAUSE Save of Setting
REC
Selection of Compensation Element
(1 element comp. 2 elements comp.)
AUTO/MANU Display of a presently set point blinking.
PLAY Marker moves upward.
STOP Marker moves downward.
REW Marker moves in left direction.
FF Marker moves in right direction.
_+
HOLD
WIDE
TELE
REC
REVIEW FOCUS
POWER
EDIT SERCH
COUNTER
RESET DATA
SCREEN FRAME SLOW
PAUSEREC
REW PLAY
STOP
FF
AUTO / MANU
ZOOM
RM-95
START /
STOP
X:YY:ZZ
Fig. Tool connection diagram
_+
HOLD
WIDE
TELE
REC
REVIEWFOCUS
POWER
EDIT SERCH
COUNTER
RESET DATA
SCREENFRAME SLOW
PAUSEREC
REW PLAY
STOP
FF
AUTO / MANU
ZOOM
RM-95
START /
STOP
X:YY:ZZ
Camera
J-6430-530-A
RM-95