Near strong magnetic fields or mechanical vibration. The camcorder may malfunction.

Near strong radio waves or radiation. The camcorder may not be able to record properly.

Near AM receivers and video equipment. Noise may occur.

On a sandy beach or anywhere dusty. If sand or dust gets in your camcorder, it may malfunction. Sometimes this malfunction cannot be repaired.

Near windows or outdoors, where the LCD screen or the lens may be exposed to direct sunlight. This damages the LCD screen.

Operate your camcorder on DC 6.8 V/7.2 V (battery pack) or DC 8.4 V (AC Adaptor).

For DC or AC operation, use the accessories recommended in these operating instructions.

Do not let your camcorder get wet, for example, from rain or sea water. If your camcorder gets wet, it may malfunction. Sometimes this malfunction cannot be repaired.

If any solid object or liquid gets inside the casing, unplug your camcorder and have it checked by a Sony dealer before operating it any further.

Avoid rough handling, disassembling, modifying, physical shock, or impact such as hammering, dropping or stepping on the product. Be particularly careful of the lens.

Keep the POWER switch setting to OFF (CHG) when you are not using your camcorder.

Do not wrap your camcorder with a towel, for example, and operate it. Doing so might cause heat to build up inside.

When disconnecting the power cord (mains lead), pull it by the plug and not the cord (lead).

Do not damage the power cord (mains lead) such as by placing anything heavy on it.

Keep metal contacts clean.

Keep the Remote Commander and button-type battery out of children’s reach. If the battery is accidentally swallowed, consult a doctor immediately.

If the battery electrolytic liquid has leaked:Consult your local authorized Sony service facilityWash off any liquid that may have contacted your skin

If any liquid gets in your eyes, wash with plenty of water and consult a doctor

100

When not using your camcorder for a long time

Periodically turn it on and let it run such as by playing back or recording images for about 3 minutes.

Use up the battery pack completely before storing it.Moisture condensation

If your camcorder is brought directly from a cold place to a warm place, moisture may condense inside your camcorder. This may cause a malfunction to your camcorder.

If moisture condensation has occurredLeave your camcorder for about 1 hour without turning it on.Note on moisture condensation

Moisture may condense when you bring your camcorder from a cold place into a warm place (or vice versa) or when you use your camcorder in a humid place as follows:

You bring your camcorder from a ski slope into a place warmed up by a heating device.

You bring your camcorder from an air conditioned car or room into a hot place outside.

You use your camcorder after a squall or a shower.You use your camcorder in a hot and humid place.How to prevent moisture condensation

When you bring your camcorder from a cold place into a warm place, put your camcorder in a plastic bag and seal it tightly. Remove the bag when the air temperature inside the plastic bag has reached the surrounding temperature (after about 1 hour).

LCD screenDo not exert excessive pressure on the LCD screen, as it may cause damage.

If your camcorder is used in a cold place, a residual image may appear on the LCD screen.