Sony HDR-SR12E, HDR-SR11E service manual English Method of Coping with Shift Lens Error Japanese

ENGLISH

1-3. METHOD OF COPING WITH SHIFT LENS ERROR

JAPANESE

about 330 msec

Note: The length of low section will vary a little depending on the conditions.

Fig. 2

Change in output voltage of R5549 on the LD-230 board

LD-230 BOARD (SIDE A) VC-516 BOARD (SIDE A)

R5526

R5525

R5549

IC1301

IC5501

R5534

R5538	R5549: No Mount
	(Short Land)

C5513

4 31

	Fig. 1
	Measurement points on the LD-230 board and the VC-516 board
1-3-1. E : 62 : 02 [Abnormality of IC for Steadyshot] Occurred
Order	Procedure
1	Turn the power OFF.
2	While measuring with an oscilloscope the output voltage of R5549 in the periphery of IC5501 on the LD-230 board, turn the
	power ON to check that the output voltage immediately after the power on change as shown in Fig. 2.
3	If the output voltage change as shown in Fig. 2, replace the lens block (Note). If it does not change as shown in Fig. 2, inspect
	the camera control circuit (IC1301 of VC-516 board) periphery.

Note: When the lens block was replaced, execute a necessary adjustment items referring to Service Manual, ADJ.

After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the handheld operation.

HDR-SR11/SR11E/SR12/SR12E_L2

1-3