Sony HDR-SR11, HDR-SR12, HDR-SR12E, HDR-SR11E

1-5

ENGLISH JAPANESE

HDR-SR11/SR11E/SR12/SR12E_L2

1-3-3.E : 62 : 12 [Shift Lens Overheating (Yaw)] Occurred

Connect by the SeusEX and perform the following process.

Order Block Page Address Data Procedure

111807430 01 Write the data. (After it starts, set it before caution is displayed.)

2118EF947 F0 Write the data.

3118EF949 01 Write the data. (Note 1)

4118EF949 00 Write the data.

5118EF947 10 Write the data.

6118EF949 01 Write the data. (Note 1)

7118EF949 00 Write the data.

811807430 00 Write the data.

9Check if the shift lens moves while setting the order 2 to 7. If the shift lens does not move,

replace the lens block (Note 2). When the shift lens moved, proceed to the order 10.

10 While setting the order 2 to 7, measure with an oscilloscope the output voltage of R5534 in the

periphery of IC5501 on the LD-230 board to check the output voltage varies.

11 If the output voltage does not vary, replace the lens block (Note 2). When the output voltage

varied, proceed to the order 12.

12 Turn the power OFF.

While measuring with an oscilloscope the output voltage of R5549 in the periphery of IC5501

13 on the LD-230 board, turn the power ON to check that the output voltage immediately after the

power on change as shown in Fig. 2.

If the output voltage change as shown in Fig. 2, replace the lens block (Note 2). If it does not

14 change as shown in Fig. 2, inspect the camera control circuit (IC1301 of VC-516 board)

periphery.

Note 1: Finish this operation within 10 seconds. If it is likely to take more than 10 seconds, set block: 11, page: 8E, address:

F949, data: 00, and then retry.

Note 2: When the lens block was replaced, execute the necessary adjustment items referring to Service Manual, ADJ.

After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the

handheld operation.

1-3-4.E : 62 : 20 [Abnormality of Thermistor] Occurred

Order Procedure

1Turn the power ON.

2Confirm the connections of flexible flat cables and connectors between the lens block and LD-230 board, LD-230 board and

VC-516 board.

3In case of no malfunction of connections, replace the lens block with new one. (Note) When the error has occurred in spite of the

lens replacement, replace LD-230 board with new one.

Note: When the lens block was replaced, execute the necessary adjustment items referring to Service Manual, ADJ.

After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the

handheld operation.