Setup

Before using your monitor, check that the following accessories are included in your carton:

•Power cord (1)•USB cable (1)•Monitor stand (1)•Warranty card (1)•Notes on cleaning the screen’s surface (1)•This instruction manual (1)

Step 1: Connect your monitor to your computer

Turn off the monitor and computer before connecting.NoteDo not touch the pins of the video cable connector as this might bend the pins.
xConnecting to an IBM PC/AT or compatible computer
to video outputIBM PC/AT or compatible computer
xConnecting to a Macintosh or compatible computer
You will need a Macintosh adapter (not supplied).Macintosh adapter (not supplied)
Macintosh or

to video output

compatible

 

computer

 

Step 2: Connect the power cord

With the monitor and computer switched off, first connect the power cord to the monitor, then connect it to a power outlet.

to AC INto a power outletpower cord (supplied)

Step 3: Turn on the monitor and computer

First turn on the monitor, then turn on the computer.The installation of your monitor is complete.If necessary, use the monitor’s controls to adjust the picture.If no picture appears on your screen•Check that the monitor is correctly connected to the computer.

•If NO INPUT SIGNAL appears on the screen, confirm that your computer’s graphic board is completely seated in the correct bus slot.

•If you are replacing an old monitor with this model and OUT OF SCAN RANGE appears on the screen, reconnect the old monitor. Then adjust the computer’s graphic board so that the horizontal frequency is between 30 – 86 kHz, and the vertical frequency is between 48 – 120 Hz.

For more information about the on-screen messages, see “Trouble symptoms and remedies” on page 13.

Setup on various OS (Operating System)

This monitor complies with the “DDC” Plug & Play standard and automatically detects all the monitor’s information. No specific driver needs to be installed to the computer.

If you connect the monitor to your PC, and then boot your PC for the first time, the setup Wizard may be displayed on the screen. Click on “Next” several times according to the instructions from the Wizard until the Plug & Play Monitor is automatically selected so that you can use this monitor.

For customers using Windows NT4.0

Monitor setup in Windows NT4.0 does not use the display driver. Refer to the Windows NT4.0 instruction manual for further details on adjusting the resolution, refresh rate, and number of colors.

6