Radio stations cannot be tuned in.
•Check that the antennas are connected securely. Adjust the antennas and connect an external antenna, if necessary.
•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.
•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).
•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 56).
•Press DISPLAY repeatedly on the receiver so that the frequency appears on the display.
Remote control
The remote does not function.
•Point the remote at the remote sensor on the receiver.
•Remove any obstacles in the path between the remote and the receiver.
•Replace all the batteries in the remote with new ones, if they are weak.
•Make sure you select the correct input on the remote.
•The AUX button on the remote is not available for receiver operation.
•When you opearate a programmed of non- Sony component, the remote may not function properly depending on the model and the maker of the component.
Error messages
If there is a malfunction, the display shows a message. You can check the condition of the system by the message. Refer to the following table to solve the problem. If any problem persists, consult your nearest Sony dealer.
If an error message appears while you perform Auto Calibration, see “Error and warning codes” (page 32) to solve the problem.
DEC. EROR
Appears when a signal the receiver cannot decode (ex.
PROTECT
Irregular current is output from the speakers. The receiver will automatically turn off after a few seconds. Check the speaker connection and turn on the power again.
If you are unable to remedy the problem using the troubleshooting guide
Clearing the receiver’s memory may remedy the problem (page 28). However, note that all memorized settings will be reset to their factory settings and you will have to readjust all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if service personnel changes some parts during repair, these parts may be retained.
Reference sections for clearing the receiver’s memory
To clear | See |
All memorized settings | |
|
|
Customized sound fields | |
|
|
76US