Specifications
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION:
With 6 ohm loads, both channels driven, from 120 – 20,000 Hz; rated 90 watts per channel minimum RMS power, with no more than 1% total harmonic distortion from 250 milliwatts to rated output.
Amplifier section
Power Output1) Models of area code U
Stereo mode (rated) (6 ohms 1 kHz, THD 1%) 90 W + 90 W
Surround mode (reference) (6 ohms 1 kHz,
THD 10%)
RMS output2) FRONT: 140 W per channel CENTER: 140 W SURROUND: 140 W per channel
1)Measured under the following conditions:
Area code | Power requirements |
U | 120 V AC, 60 Hz |
|
|
2)Reference power output for front, center and surround speakers. Depending on the sound field settings and the source, there may be no sound output.
Inputs |
|
Analog | Sensitivity: 800 mV/ |
| 50 kohms |
Digital (Coaxial) | Impedance: 75 ohms |
Outputs (Analog) |
|
AUDIO OUT | Voltage: 800 mV/ |
| 10 kohms |
SUBWOOFER | Voltage: 2 V/1 kohm |
Tone |
|
Gain levels | ±6 dB, 1 dB step |
Reproduction frequency range:
28 – 20,000 Hz
FM tuner section
Tuning range | 87.5 - 108.0 MHz |
Antenna | FM wire antenna |
Antenna terminals | 75 ohms, unbalanced |
Intermediate frequency
10.7 MHz
AM tuner section
Tuning range
With
| 530 – 1,710 kHz3) |
With | |
| 531 – 1,710 kHz3) |
Antenna | Loop antenna |
Intermediate frequency
450 kHz
3)You can change the AM tuning scale to 9 kHz or 10 kHz. After tuning in any AM station, turn off the receiver. While holding down TUNING MODE, press ?/1. All preset stations will be erased when you change the tuning scale. To reset the scale to 10 kHz (or 9 kHz), repeat the procedure.
Video section
Inputs/Outputs
Video: | 1 |
COMPONENT VIDEO:
Y:1
PR/CR: 0.7
80 MHz HD Pass Through
General
Power requirements
Area code | Power requirements |
U | 120 V AC, 60 Hz |
| |
Power output (DIGITAL MEDIA PORT) | |
DC OUT: | 5 V, 700 mA |
Power consumption |
|
|
|
Area code | Power consumption |
|
|
U | 200 W |
|
|
Power consumption (during standby mode) 0.3 W
continued
77US
Information Additional