After connecting all the components, speakers, and AC power cord, output a test tone to check that all the speakers are connected correctly. For details on outputting a test tone, see page 18.
If no sound is heard from a speaker while outputting a test tone or a test tone is output from a speaker other than the one whose name is currently displayed on the receiver, the speaker may be
Make sure that you turn down the volume before you turn off the receiver. When you turn on the receiver, the volume remains at the level you turn off the receiver.
Performing initial setup
operations
Once you have hooked up the speakers and turned on the power, clear the receiver’s memory. Then specify the speaker parameters (size, position, etc.) and perform any other initial setup operations necessary for your system.
Tip
To check the audio output during settings (to set up while outputting the sound), check the connection (see page 19).
Before using your receiver for the first time, or when you want to clear the receiver’s memory, do the following.
1 Press ?/1 to turn off the receiver. | Hooking | |
2 Hold down ?/1 on the receiver for | ||
| ||
5 seconds. |
| |
“INITIAL” appears in the display. |
| |
The following are reset to their factory | Up | |
settings. | ||
• All settings in the SET UP, LEVEL and | and | |
TONE menus. | ||
• All sound field parameters. | Setting | |
| ||
• All preset stations. |
| |
• The sound fields memorized for each |
| |
INPUT SELECTOR and preset stations. | Up | |
• The master volume is set to “VOL | ||
the | ||
MIN”. | ||
Speaker | ||
Before using your receiver for the first time, | ||
Performing initial setup |
| |
operations | System | |
adjust MAIN MENU parameters so that the | ||
| ||
receiver correspond to your system. For the |
| |
adjustable parameters, see the table on page 43. |
| |
See pages |
| |
|
13GB
13 | 28/4/2003, 11:58 AM |