Changing the factory setting of an input selector button
If the factory settings of the input selector buttons do not match your system components, you can change them. For example, if you have a CD player and you do not have a DVD player, you can assign the DVD button to your CD player.
1 Hold down the input selector button whose input source you want to change (for example, DVD).
2 Press the corresponding button of the component you want to assign to the input selector button (for example,
1 – CD player).
The following buttons are assigned to select the input source:
To operate | Press |
CD player | 1 |
|
|
VCR (command mode VTR 2*) | 2 |
|
|
VCR (command mode VTR 3*) | 3 |
|
|
DVD player | 4 |
|
|
TV | 5 |
|
|
DSS (Digital Satellite Receiver) | 6 |
|
|
Tuner (this receiver) | 7 |
|
|
DCS (Digital CS Tuner) | 8 |
|
|
BSD (Digital BS Tuner) | 9 |
|
|
Tuner (Component Tuner) | 0/10 |
|
|
*Sony VCRs are operated with a VTR 2 or 3 setting. These correspond to 8mm and VHS respectively.
Now you can use the DVD button to control the CD player.
To reset a button to its factory setting
Repeat the above procedure.
To reset all the input selector buttons to their factory setting
Press ?/1, AV ?/1 and MASTER VOL – at the same time.
36GB
36 | 28/4/2003, 11:58 AM |