Dolby Digital or DTS multi channel sound is not reproduced.

•Check that the DVD, etc. you are playing is recorded in Dolby Digital or DTS format.

•When connecting the DVD player, etc., to the digital input jacks of this receiver, check the audio setting (the settings for the audio output) of the connected component.

The FM reception is poor.

•Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna as shown below. If you connect the receiver to an outdoor antenna, ground it against lightning. To prevent a gas explosion, do not connect the ground wire to a gas pipe.

Outdoor FM antenna

Receiver

RDS does not work.b)

•Make sure that you are tuned to an FM RDS station.

•Select a stronger FM station.

The RDS information that you want does not appear.b)

•Contact the radio station and find out whether they actually provide the service in question. If so, the service may be temporarily out of order.

There is no picture or an unclear picture appears on the TV screen or monitor.

•Make sure you have connected the video output of your video component to the TV.

•Move your audio components away from the TV.

The source image input to the HDMI jack on the receiver is not output from the TV.a)

ANTENNA

U

AM

• Check the HDMI connection.

• Depending on the playback component,

you may need to set up the component.

Refer to the operating instructions

Ground wire (not supplied)

To ground

Radio stations cannot be tuned in.

•Check that the antennas are connected securely. Adjust the antennas and connect an external antenna, if necessary.

•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning (page 45).

•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).

•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 47).

supplied with each component.

Information Additional

continued

55GB