Remote control
The remote does not function.
•For receiver operation, you can only use
the DISPLAY button when the TUNER input is selected.b)
•Point the remote at the remote sensor on the receiver.
•Remove any obstacles in the path between the remote and the receiver.
•Replace all the batteries in the remote with new ones, if they are weak.
•Make sure you select the correct input on the remote.
a)Except for models of area code MX, E51, AR.
b)Models of area code CEL, CEK only.
Error messages
If there is a malfunction, the display shows a message. You can check the condition of the system by the message. Refer to the following table to solve the problem. If any problem persists, consult your nearest Sony dealer.
If an error message appears while you perform Auto Calibration, see “Error and warning codes” (page 25) to solve the problem.
PROTECT
Irregular current is output from the speakers. The receiver will automatically turn off after a few seconds. Check the speaker connection and turn on the power again.
If you are unable to remedy the problem using the troubleshooting guide
Clearing the receiver’s memory may remedy the problem (page 22). However, note that all memorized settings will be reset to their factory settings and you will have to readjust all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer.
Reference sections for clearing the receiver’s memory
To clear | See |
All memorized settings | |
|
|
Customized sound fields | |
|
|
56GB