Connections (Continued)

Basic TV Connections

Make one of the following connections, depending on the capabilities of your TV.

RF coaxial connection

Connect the ANTENNA OUT jack on the DVD/VCR Receiver to the antenna in jack on the TV using the 75-ohm Coaxial Cable supplied (R).

Note

If you use this connection, tune the TV to the DVD/VCR Receiver’s RF output channel (CH 3 or 4).

How to set the DVD/VCR Receiver’s RF output channel

When the DVD/VCR Receiver is turned off, press and hold CH/PRESET(+/–) on the front panel for about five seconds to change the RF output channel (CH 03 or CH 04). “RF-03” or “RF-04” appears in the display win- dow.

Audio/Video connection

1

Connect the VIDEO OUT jack on the DVD/VCR

Receiver to the video in jack on the TV using the

 

supplied video cable (V).

2 Connect the Left and Right AUDIO OUT jacks on the DVD/VCR Receiver to the audio left/right in jacks on the TV (A) using the supplied audio cables.

Note

If you use this connection, set the TV’s source selector to VIDEO.

Rear of TV

ANTENNA

AUDIO INPUT

VIDEO

COMPONENT/PROGRESSIVE

S VIDEO

INPUT

INPUT

 

SCAN VIDEO INPUT

INPUT

 

L

R

L

Pr

Pb

Y

 

R

A

V

C

S

Rear of DVD/VCR Receiver

Optional TV Connections

Note

DVD playback can ONLY be done using the S VIDEO OUT and COMPONENT VIDEO OUT connection options below. The tuner and VIDEO will still output through the ANTENNA OUT (R) or AUDIO/VIDEO OUT (A, V) jack. (See left)

S Video Connection

1

Connect the S VIDEO OUT jack on the DVD/VCR

Receiver to the S Video in jack on the TV using the

supplied S Video cable (S).

2 Connect the Left and Right AUDIO OUT jacks on the DVD/VCR Receiver to the audio left/right in jacks on the TV using the supplied audio cables

(A).

Component Video (Color Stream®) connection

1

Connect the COMPONENT VIDEO OUT jacks on

the DVD/VCR Receiver to the corresponding in

jacks on the TV using a component video cables

(C).

2 Connect the Left and Right AUDIO OUT jacks of the DVD/VCR Receiver to the audio left/right in jacks on the TV (A) using the supplied audio cables.

Progressive Scan (ColorStream® pro) connection

If your television is a high-definition or “digital ready” television, you may take advantage of the DVD/VCR Receiver’s progressive scan output for the highest video resolution possible.

If your TV does not accept the Progressive Scan for- mat, the picture will appear scrambled if you try Progressive Scan on the DVD/VCR Receiver.

1

Connect the COMPONENT VIDEO OUT jacks on

the DVD/VCR Receiver to the corresponding in

jacks on the TV using a component video cables

(C).

2 Connect the Left and Right AUDIO OUT jacks of the DVD/VCR Receiver to the audio left/right in jacks on the TV (A) using the supplied audio cables.

Notes

Set the Progressive Scan to “On” on the DVD setup menu for progressive signal, see page 21. Progressive scan does not work with the analog video connections (yellow VIDEO OUT jack).

12