1 In the standby mode, press PICTURE PROFILE.
2 Select a picture profile number by turning the SEL/PUSH EXEC dial, then press the dial.
[PP1] through [PP6] are available.
3 Select [SETTING] by turning the SEL/ PUSH EXEC dial, then press the dial.
4 Select an item to be adjusted by turning the SEL/PUSH EXEC dial, then press the dial.
5 Adjust the picture quality by turning the SEL/PUSH EXEC dial, then press the dial.
Item | Adjustment |
|
|
[COLOR | |
LEVEL] | |
|
|
[COLOR | |
PHASE] |
|
|
|
[SHARP- | 0 (softer) to 15 (clearer) |
NESS] |
|
|
|
36Recording
Item | Adjustment |
|
|
[SKINTONE | To make wrinkles less |
DTL] | noticeable by suppressing the |
| outlines on the part in skin color |
| to be enhanced. |
| [OFF]: No adjustment |
| [TYPE1] (the color range |
| recognized as a skin color is |
| narrow) to [TYPE3] (the color |
| range recognized as a skin color |
| is wide) |
|
|
[SKINTONE | Sets the enhancement level of |
LVL] | the edge of the part in skin color |
| for setting [SKINTONE DTL]. |
| [HIGH] (to enhance strongly) to |
| [LOW] (to enhance weakly) |
|
|
[AE SHIFT] | |
|
|
[AGC | Select the upper limit for the |
LIMIT] | auto gain control (AGC) |
| ([OFF], 12dB, 6dB, 0dB). |
| [OFF] is 18dB. |
|
|
[AT IRIS | Select the highest aperture |
LMT] | value for the automatic |
| adjustment (F11, F6.8, F4). |
|
|
[WB SHIFT] | |
| to +7 (to make white parts |
| reddish) |
|
|
[ATW | To set the auto white balance |
SENS] | operation under a reddish light |
| source such as an incandescent |
| lamp or candle, or under a |
| blueish light source such as in |
| outdoor shade. |
| [HIGH] (reddishness or |
| blueishness is reduced) to |
| [LOW] (reddishness or |
| blueishness is increased) |
| [ATW SENS] is not effective |
| under a clear sky or the sun. |
|
|
[BLACK | [ON]: To raise the γ curve |
STRTCH] | characteristics of the dark part |
| so that the gradation of the dark |
| part is reproduced better. |
|
|