For connection to an
Note
When a CCU is used in combination, this connector functions as the trunk signal input/output. Do not connect any remote control device to this connector.
gTEST OUT connector (BNC type) To output an analog signal.This supplies a VBS signal, an
Note
The VBS output signal has no subcarrier
Connect a channel 1 audio signal and set the switch according to the connected source device.
LINE: When a
MIC: When an external microphone is connected
+48V: To supply power of +48 V to the connected external microphone
iMIC 1 (microphone 1) select switch Select the microphone for channel 1.FRONT: To use the microphone connected to the MIC 1 IN connector
REAR: To use the microphone connected to the AUDIO IN CH1 connector
jAUDIO IN CH2 connector (XLRswitch
Connect a
kSDI (serial digital interface) connector (BNC type) For
You can select from among camera line signal, return signal, and VF signal for the output with a menu operation.
Installation
Connecting a Camera Control Unit (CCU)
When operating the camera in a system with a CCU, connect between the CCU connector of the camera and the CAMERA connector of the CCU, using a triax cable.
When required, secure the cable, using the supplied cable clamp belt.
To use the cable clamp belt
1 Insert the belt bracket C into hole A or B of the cable clamp belt.C
B
A
2 1 Remove the back
2
1
3 1 Release the buckle, 2 bundle the cable with the belt, 3 then lock the buckle again.
1
3
2
Installation 9